Link Labs DocumentationLL-RLP-20 and LL-RXR-27 Modules Evaluation BoardHow to place the evaluation board into bootloader mode manually

How to place the evaluation board into bootloader mode manually

The evaluation boards' module can be placed in bootloader mode by sending appropriate host interface commands to the module or manually by driving the BOOT pin low while resetting the module.  This article describes how to manually place the evaluation board's module in bootloader mode.

Procedure

  1. Short the evaluation board's BOOT pin by placing a jumper on the BOOT header.
  2. Press and release the RESET button.
  3. Remove the jumper from the BOOT pin.

The module is now in bootloader mode.

Procedure

0 Comments

Add your comment

E-Mail me when someone replies to this comment