Step 2: Setup your Network Tester

Power on the network tester.

Insert AA batteries into the network tester, fasten the antenna to the SMA jack, and then switch it on.

Power on the network tester.

Wait for the network tester to connect.

The network tester will automatically connect to the nearest OPEN-network Symphony Link Gateway. It takes up to a minute to establish the first connection.

As the connection initializes, the D1 diode will flash. When the connection is made, the network tester beeps once and the diode remains on.

Wait for the network tester to connect.

The three buttons navigate the network tester's menus. Pressing the left button takes you up one level, the middle button toggles among selections, and the right button selects the highlighted option.

Toggle to and select Network Diagnostics to see the status of the connection, as well as information about the gateway to which the tester is connected.

Get a GPS fix.

The network tester will automatically obtain a GPS fix as long as it has an unobstructed view of the sky. It can take several minutes to obtain a new fix. When the tester has a fix, the D3 diode turns on (the right-hand diode).

Get a GPS fix.

To get information about the GPS fix, toggle to and select GPS Diagnostics.

0 Comments

Add your comment

E-Mail me when someone replies to this comment